HQ RISE · Thin-strip joining
Thin metal strip laser butt welding for production changeovers
The HQ-MT1500-I is an automatic thin-strip butt-welding system. Its published range is 0.03–0.5 mm material thickness and strip width below 130 mm. Evaluate the actual strip and downstream process before choosing a configuration.
Equipment selection at a glance
| Selection point | Published information | Confirm with your sample |
|---|---|---|
| Joining process | Thin-strip butt welding | Joint geometry and alignment |
| Thickness | 0.03–0.5 mm | Exact grade, temper and coating |
| Strip width | Below 130 mm | Strip dimensions and edge condition |
| Integrated operations | Alignment, blade cutting and leveling | Joint flatness and feed clearance |
| Process acceptance | Application-specific sample testing | Strength, appearance and downstream feeding |
For terminal, connector and precision stamping manufacturers
If your production uses narrow copper, phosphor-bronze or stainless strip, first identify whether end joining is required during strip changes. These industries are possible evaluation contexts; they are not a claim of proven integration into every stamping line.
Provide the feeder and guide arrangement, die clearance and required joint acceptance criteria. Agree on how any welded section is identified and handled in production. Test the joint through the relevant process before confirming integration.
Send these details for an application review
- Material grade, temper, coating, thickness and width.
- Photos of strip ends and the existing joining or changeover process.
- Required joint strength, flatness and appearance.
- Downstream guide and die clearances and feeding requirements.
- Destination country, output target and installation conditions.
Review the HQ-MT1500-I product specifications and sample-testing checklist, then contact HQ RISE for a sample review.
Questions about strip joining
What does the HQ-MT1500-I join?
The HQ-MT1500-I joins the ends of thin metal strips by automatic butt welding. The published thickness range is 0.03–0.5 mm and strip width is below 130 mm. It includes alignment, blade cutting and leveling.
Can it be evaluated for progressive stamping strip changes?
It is a candidate for joining thin strip ends where the material and dimensions fit the published range. Confirm whether the joint can pass through your guides and die, and validate joint strength, flatness and feed behavior on representative strip. A stamping application is not established by a brochure specimen alone.
Which materials should be submitted for testing?
The brochure lists stainless steel, carbon steel, brass, phosphor bronze, nickel–copper alloy, nickel silver, copper, aluminum and tin-plated copper. Provide the exact grade, temper, thickness, width and coating; a listed material does not guarantee suitability for every production requirement.
Is this machine intended for general sheet-metal fabrication?
The published application is thin-strip end joining. Large sheet assemblies, thick structural welds and general handheld welding are outside the documented application and require a different equipment assessment.